-40%

Ford Remote Start Kit Gas or Diesel w/ 2 Fobs

$ 26.37

Availability: 88 in stock
  • Brand: Unbranded
  • Condition: New

    Description

    REMOTE START KIT
    for the following
    Ford cars and trucks
    (or most vehicles with automatic transmissions)
    AEROSTAR 92-97
    BRONCO 92-96
    EXCURSION 00-04
    EXPEDITION 97-06
    EXPLORER 98-04
    FORD F150 PICKUP 04 Heritage
    FORD F150 PICKUP 92-03
    FORD F250 PICKUP 92-98
    FORD F250 PICKUP 99 (under 8500 GVW)
    FORD F250SD PICKUP 99-04
    FORD F350 PICKUP 92-97
    FORD F350SD PICKUP 99-04
    FORD F450 PICKUP 92-97
    FORD F450SD PICKUP 99-03
    FORD F550SD PICKUP 99-03
    LINCOLN & TOWN CAR 90-04
    LINCOLN CONTINENTAL 91-02
    LINCOLN MARK SERIES 93-96
    MOUNTAINEER 98-04
    MUSTANG pre 1996
    NAVIGATOR 98-06
    RANGER 95-04
    SABLE 90-04
    TAURUS 90-04
    THUNDERBIRD 94-97
    VILLAGER 93-95,
    WINDSTAR 95-03
    This kit will actually work on almost any car or truck with an automatic transmission as long as you have a wiring schematic for the ignition switch.
    Fob is 2&1/4" x 1&1/2" by 1/4"
    Range ~100 ft+ depending on conditions and installation.
    The installation is very simple.
    There are only 3 wires (plus ground) that connect to the ignition switch.
    I provide the installation instructions for all the vehicles listed above including color codes of wires involved
    Installation can be done in about 1 hour and requires just the basic garage tools.
    Comes with two remote fobs.
    I get a lot of questions along the lines of "will this work on my car / truck / quad / mule / backhoe / generator / blender?" and thought I'd try to answer them once and for all.
    As long as you don't have an RFID in your key and the tranny is an automatic this will work with most any gas or diesel vehicle where you can connect to the wires that are hot when you'd otherwise have the normal key in the "run" and "start" positions. Glow plug operation is the same as when using the key: you turn on the ignition with one button, wait for as long you'd wait when using the key, and then press the "start" button on the remote. Note that if your vehicle has a manual glow plug switch, or requires you to turn the key to a "glow plug position," this remote can't activate them. You either need to be able to start it cold or sadly, this is not the remote for you.
    I include good instructions (including pin numbers and wire colors) for the vehicles listed in the item description. But again, even if your vehicle (or mule, or generator, or anything with a engine with an electric starter) is not listed, this remote can pretty much work with anything as long as it doesn't use a "chip" in the key, doesn't require the use of manual glow plugs, and it has an automatic transmission (or otherwise never needs to worry about moving when you start it). All you need to do is connect to the two wires that "run" and "start" it (plus two more connections to +12VDC and Ground).
    If your key does have a chip in it, this won't work without some additional modification. I haven't done it myself but you basically use a spare key (or even just the chip part of it if you can get it out, or cut the head off) with a coil of wire around it that then also goes around the ignition switch. The coil around the chip energizes it electromagnetically and then the coil around the key cylinder acts as an antenna to transmit the code to the vehicle's system. You can also possibly just glue the chip/head under the cylinder, check out this howto:
    http://www.ehow.com/how_7601475_bypass-transponder-key-jeep-wrangler.html
    If you google on it I imagine you could find more exact instructions. You can also buy a module such as the Valiant TR1 ( at JC Whitney) or the like that does the same thing.
    This can also be used for generators, mules, etc, anything with a 12V system where you can connect to the Run and Start wires.
    I do NOT recommend installing this (or ANY remote start system) to a vehicle without an automatic transmission. While there's no technical reason you couldn't bypass the clutch switch somehow, I just don't see any reliable way to be absolutely sure the vehicle might not move when you started it. Maybe if you included both a "neutral" switch and a "parking brake" switch. The thought still creeps me out.
    To wrap up. Will this remote work with your vehicle? If it's listed in the item description, yes. If it's not, but doesn't have a chip in the key or a manual transmission, still probably yes. If it has a chip in the key but not a manual tranny, yes with some modifications. If it has a manual tranny, no.
    This is a very simple installation  that anyone can do----
    Other REMOTE START kits suggest  "professional installation"
    ----Free shipping to all USA locations---
    --Shipping to Canada via USPS Priority mail is --
    I ship worldwide.
    Please email me for shipping cost to countries not listed above.