LAB FRAME, ROTOCON NFZ23, 1/2" FIBERGLASS RODS, 2'W x 3'H

Description

ROTOCON LAB FRAME, Model NFZ23, 2 Ft Wide by 3 Ft High and approximately 18 Inches Deep. This model exhibits the "No Base Support Rod" design. Made of 1/2 inch round white solid Fiberglass rods connected and anchored by our tough Rotocon Zinc-alloy Assembly Clamps using nickel-plated steel nuts and screws. Sturdy construction with rod support, horizontally and vertically, at 12 inch intervals will accommodate light to medium loads providing a very strong lattice support.
If this lab frame is too tall or wide for your space we can reduce the length of the rods to your specifications at no extra charge. Simply, send me a message, along with your order, describing your desired height or width and your order will ship within the usual 4 days.
There are four anchoring bases which can be attached to your table top, hood base, plywood base or floor to prevent tipping over. These clamps can connect at 10 degree intervals and will allow much versatility in design and construction. Detailed suggested assembly instructions for frames as pictured are included. The kit contents are as follows: 4 each 1/2 inch round white solid Fiberglass rods 24 inches in length, 5 each 1/2 inch round white solid Fiberglass rods 36 inches in length, 16 sets RT-1/2 Zinc-alloy Slip-
On Assembly Clamps, 2 sets M-90 Zinc-alloy Mounting Base and 8 stainless steel screws for anchoring.  Assembly required. Tape measure, Phillips and flat blade screwdriver may be needed but not included in package. (This design also comes in various other sizes (up to 6' W and 6' H) and strengths, with connectors made of
Zinc-alloy, anchors made of Zinc-alloy or Aluminum-alloy, and rods made of 1/2" round tubular stainless steel, solid stainless steel, solid aluminum or white fiberglass rods). These other models can be found in our rotocon store.