REMOTE START FOR JEEP WRANGLER 2007 - 2017 PLUG & PLAY - KEY START

Description

JEEP WRANGLER REMOTE START
Plug & Play Remote Starter Kit
Just released our Wrangler plug & play remote start is the easiest out there to install! Remote start installation
is fast and easy takes most consumers about 30 minutes to an hour. Once installed simply press the lock button on your OEM remote 3 times to start your JK
Wrangler
.
Full kit all parts included/
Comes with installation instructions.
Easy programming no dealer scantool needed.
Quick, easy, PLUG & PLAY installation
Will not work on 2018 JL Wrangler.
Compatibility Requirements
2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 Jeep Wrangler
10th letter of your VIN # must be an 7, 8, 9, A, B, C, D, E, F, G, H
Must be key start ignition.
Wrangler
must have power locks / keyless entry
Automatic transmission only will not work on manuals
Installation Help
NOTE: 2017 MODELS THE INSTALL IS A BIT MORE DIFFICULT! Still plug & play but more disassembly. Contact us with any questions.
Remove the drivers center under dash panel from your wrangler. The top is held on by clips and then the panel hinges down and pulls off. Next remove 3 T20 torx from the steering column cover then separate the 2 halves of the cover and remove the lower half from your Jeep. Now you can plug our t-harness in between the module below the ignition switch. The light on the module should be red. If not open and close the driver door. Next turn the key on (don't start) so the cluster turns on and the light will start flashing green. Turn the key off remove and press the UNLOCK button once on the OEM remote key fob. The light will turn solid green and go out. Done! Hook up the optional parking light wire if necessary.
Installation Video:
Coming Soon!